37-ft., 62-cubic yard Frameless Scrap Trailer
   You don't see savvy scrap haulers buying the same trailer again and again unless it's making them money, lots of money. Clement ScrapStar, Mark II is designed and configured for maximum profitability with high-strength, abrasion resistant steel (AR450) that

gives you the ability to haul the full spectrum of scrap. Premium components, which are options on competitor's trailers are standard of every Scrapstar. That's because money is made on the road, not in a repair shop. Add Clement's superior design and construction and you have a solil moneymaker.

Preminum Components are standard on the ScrapStar
because money is made on the road, not in the repair shop.

Clement Bathtub Bodies
The Clement Bathtub body, with its 8 inch radius wrap floor with no center seam, is supported by longitudinals rather than cross members. This design has been so successful that it has become the most imitated body in the industry.



Urethane Paint
A Class-8, truck-quality urethane paint is applied to ensure maximum protection and long life.

102” Axles by Meritor
Proven in hundreds of thousands of trailers, the 25,000# axles used in Clement Scrap trailers feature common inner and outer bearings. In combination with Meritor's parallel spindle, both axle and bearing life is substantially increased.


Clement’s Inverted Cylinder
With an inverted cylinder there’s no doghouse. An inverted cylinder has no ledges to collect dirt, water and ice, so the cylinder packing remains clean with no dirt pulled into the system. In an inverted cylinder, oil lays on the seals when the trailer is not in use, keeping the seals lubricated to prevent dryout and cracking.

   CHASSIS
   Suspension: 50,000 # Single Point - 3    Leaf Axles: (2) 102", 25,000 lb, 5"       Round, Common Inner/Outer Bearings    Wheels: 8.25 x 24.5, 10 Hole       
      Hub-Piloted Disc
   Tires: 11 x 24.5 Radial
   Hubs: 10 Hole Pilot Hub
   Brakes: Air 16 1/2" x 7" Outboard Cast       Drum;
   ABS: 2S 1M Axle Spacing: 51"
   Lights: 12 Volt Sealed Beam, Rubber       Grommet
   Wiring: Sealed Harness Modular Plug In    Mud Flaps: Rubber Rear Only
   Draft Arms: 3"x 4"x 1/8 Tubing
   King Pin Plate: 1/4" AR450       (Rocking/Breakaway)
   Back-up Alarm: Yes

   BODY
   Type: Steel Bathtub style body for steel       scrap & demolition
   Floor: Full Wrap: 1/4" AR450
   Sides: 3/16" AR450
   Tailgate: Barndoor 3/16" AR450
   Front: 3/16" AR450
   Paint: One color urethane enamel over       primed surface
   Longitudinal: 4"x 8"x 3/16" Tubing
   Top Rail: 4"x 4"x 3/16" Tubing
   Side Braces: 3/16"
   Hoist Housing: None - Inverted Outside       Hydraulic Cylinder