The
ultimate for stockpiling and dumping asphalt
Clement's Quarter Frame steel end dump has become the standard against
which other trailers are now judged. With the high dump point of a frame and
the stabilizer arms of a frameless, the Clement Quarter Frame is the ultimate
trailer for stockpiling and dumping asphalt into a dumping machine. The Clement
Quarter Frame offers the paving contractor the opportunity to truly apply the
proper trailer to
his particular job requirements.
In the Quarter Frame, Clement has combined very desirable
characteristics with a wide range of options so that operators can determine
just what's best for them, and customize the unite to assure a maximum return
on investment.
The Standard by
which other trailers are judged —
Meritor
102-inch, 25,000-lb. axles in combination
with hub-piloted wheels
Proven
on hundreds of thousands of trailers, 25,000-lb. Meritor axles feature common
inner and outer bearings. Combined with Meritor's parallel spindle, both axle
and bearing life are substantially increased. With hub-piloted wheels there
are no inner nuts and all nuts have right-hand threads. Maintenance time and
costs are reduced
Dumps with wheels on the ground
Clement's Quarter Frame steel end dump dumps with wheels on the ground. Our
Quarter Frame also gives you higher spill points.
Air-Lift gate with 81-inch
opening and larger
The
Clement Quarter Frame's standard gate has a minimum 81-inch opening that improves
discharge. Mud flaps are attached to the tailgate to reduce flap damage. Barn
door tailgates are optional
Clement's inverted cylinder
With
an inverted cylinder there's no doghouse to interfere with the load. Since
the kingpin is located forward, the bridge length is longer allowing greater
gross weight. An inverted cylinder has no ledges where dirt can collect and
contaminate the system. Because the cylinder is externally mounted, it is
easier to service and faster to remove.
CHASSIS
Suspension: 50,000 # Single
Point - 3
Leaf Axles: (2) 102", 25,000 lb, 5" Round,
Common Inner/Outer Bearings
Wheels: 8.25 x 24.5, 10 Hole Hub-Piloted
Disc Tires: 11 x 24.5 Radial Hubs:
10 Hole
Pilot Hub Brakes: Air 16 1/2" x 7" Outboard
Cast Drum; ABS: 2S 1M
Axle Spacing: 51"
Lights: 12 Volt Sealed Beam, Rubber
Grommet
Wiring: Sealed Harness Modular Plug
In
Mud Flaps: Rubber Rear Only
King Pin Plate: 1/4" AR450 (Rocking/Breakaway)
Back-up Alarm: Yes
BODY
Type: Steel Bathtub style body
Floor: 10 gauge HT50
Sides: 12 gauge HT50
Tailgate: 10 gauge HT50, Top Hinged,
Air Locked
Front: 12 gauge HT50
Paint: One color urethane enamel over
primed surface
Longitudinals: 4"x 8"x 3/16" Tubing
Arms: 3/16" fabricated tubing
Stabilizer: 3" x 4" x 1/4"
Top Rail: 4"x4"x 3/16" Tubing
Side Braces: 10 & 12 gauge HT50 fabricated
channel Intermediate
Side Braces: 12 gauge HT50 fabricated
channel
Hoist Housing: 10 gauge HT50
