Clement's Slope-nose bathtub body eliminates dead weight, allowing for maximum payloads. Up to 2,000 pounds lighter than comparable steel units, the ES3S2834 can match the weight of most aluminum trailers.
Built on a firm foundation - This unit's strength starts with a super strong, full-length, fabricated I-beam frame that's 42-inches wide and 23-inches deep.

 

The 3rd axle air-ride/air-lift suspension comes with a 25,000-lb. rated axle providing the strength and added braking capacity for heavy loads. Installed to provide for maximum lift when not in use, the axle comes with adjustable pressure settings for regulating axle load.

No washboarding
the 1/4-inch AR450 steel wrap floor is welded over 5 x 5 inch longitudinals with no cross-members. This eliminates floor washboarding and premature floor wear. AR450 steel has nearly 3 times the strength of the hi-tensile steel used in other makes of trailers.

Clement's one-piece tailgate of AR450 is dual-acting with both extra-wide and strong top and barn door hinges.

Cold weather advantage
Cold weather is less of a problem. The tractor's exhaust is circulated beneath the trailer's floor helping to keep trailer surfaces from freezing and loads from sticking.



59"sides and ends yield a 34-cubic yard capacity. 3/16" AR450 steel sides teamed with the 1/4" AR450 floor results in maximum strength. 8" radius corners help prevent materials from sticking.

Every Clement trailer gets a top-notch paint job In Clement's state-of-the-art paint facility. Atmospheric corrosion is reduced by the application of a special phosphate solution to the steel before it is painted. A urethane primer and paint are then applied, resulting in a trailer with the best in protective finishes and a llong-lasting shine.

95-235 Standard hoist/ exterior    cylinder
Slope-nose bathtub-style body
Longitudinals: 5" x 5" x 3/16"
   wall tubing Side braces
King pin plate: 3/8" steel
Tailgate: dual-acting with top and    barn door hinges
Rear lights mounted in light box Landing gear: 2-speed, frametype Man stand on the headboard

Full-length fenders of aluminum
tread plate
Suspension: Transpo with
    52,000-lb. rating.
Lift third axle Axles: (3) 25,000 lb.    with common bearings, 96"
   wide track
Wheel bearings: same sie inner    and outer bearings
Brakes: 16-12" x 7" w/WABCO
4s-2m ABS Braking system
Outboard cast brake drums
Haldex automatic slack adjusters
Wheels: (12) 11x24.5 Bridgestone
   R-293, 16 ply
Sealed beam lights in rubber
   grommets
Sealed wiring harness
Mid-ship turn signal
Rear mud flaps and flap in front
   of air axle
Finish: steel pre-treated with
   phosphate coating, urethane
   primer, urethane paint

---